1/3/2024 0 Comments Kool air dip dying![]() If the orange and blues were mixed at the same time, it might have been muddier than how it turned out with this over-dyeing method. Orange and blue are complementary colors, so adding blue and green to that orange base worked to tone down the shades. On one, a few shades of red and pink were overlapped, for kind of a tonal coral on the other, blues and greens were used, which mixed with the light orange base to be more muted versions of those colors. ![]() They were then over-dyed each separately, with totally different colors (below). Those are two hanks of bare yarn that were dyed using the same microwave method with a couple of shades of orange/yellow, for a tonal hue. Using our Simply Wool & Simply Alpaca yarns as bases instead of Bare can get you beautiful, darker, toned-down color results! There’s also the option of dyeing vibrant Kool-Aid colors over the top of other colors. The left-hand one was actually partially dyed on the stove first, for the dark solid green section and then overdyed more in the microwave, and the right-hand one was using the same microwave method above. Below are two more hanks of the same Bare Superwash Merino Twist dyed with similar Kool-Aid colors in different ways. This method is great for variegated looks with the white showing through, but if you want a more saturated look, just use a bit more water and stir to mix the dye around for full coverage. It could take a couple of days to dry completely. Shake it out, and hang it to dry over a hanger, shower curtain rod, or coat rack. Step 8: Gently squeeze the water out in the sink, then roll the hank up in a big towel, and gently press on it to squeeze the remaining water out. If you want to get the vinegar smell out, you may choose to wash the yarn with a wool wash now, but rinsing is sufficient to prepare it to knit. Step 7: Rinse it in water that’s the same temperature as the yarn very gently. As long as there is no colored dye left in the water, it means the dye has set into the yarn, not in the water. Below, left you can see how the water is cloudy, but white, no dye. Step 6: When the water looks clear, the dye is set! Dump the yarn into a colander to cool to room temperature. Tip: Never microwave for more than 1 minute at a time to avoid scorching the yarn. The yarn shown here was flipped upside down with more drink powder added and microwaved a minute 3 more times, for a total of 4 dye applications. Your exact process may vary depending on how you want your yarn to look. ![]() If more color is desired, repeat Steps 2-4, repositioning the yarn and dyeing more, until you’re happy with it. Step 5: When you take it out, the powder should be mostly absorbed into the yarn. Step 4: After the drink powder has been sprinkled on as desired, cover the yarn with plastic wrap and microwave it for 1 minute. Take note of the color wheel to strategize your color blending. Step 3: Next sprinkle on some powder! For this yarn, the oranges, greens, and blues were purposely allowed to overlap and mix. For this hank, the goal was all-over speckled variegation, so it was purposely left messily positioned in the bowl. Step 2: If you want to dye the hank in a certain pattern, like with different colors on different sections of the loop, then position the yarn intentionally. Step 1: Place your hank in a glass or otherwise microwave-safe bowl with just enough vinegar water to cover the top of it.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |